Hey, I was wondering what is the Highest frequency I can do on the OSL without losing data, every example shows 200 Hz and runs get choppy and there is data drops at 500 Hz as other posts have indicated the highest I have seen mentioned is 500 theoretically, I am asking this because I wish to do at least 500+ frequency for my experiment and test phase variables which are updating in real time at a much faster rate than what the OSL’s 200 Hz examples and if there is someway to do it or some examples or methods to avoid this bottleneck.
Dear @Sani_Hasan
The limiting factor from going above the 500 Hz is the communication with Dephy actuator from my experience. Even at 500 Hz it may be not stable.
However do you need your OSL controller to run at 500 Hz ? Can you have different frequency loop ? One faster for your phase computation and one slower for the control of the OSL ?
Kind regards,
Louis